CAUTION:Read and follow all Safety Rules and Operating Instructions Before Every Use of this Product.SAVE THESE INSTRUCTIONS.Sears, Roebuck and Co., H
• 7 •Recommended minimum AWG size for extension cords for battery 8.2 chargers:25 50 100 150(7.6) (15.2) (30.5) (45.6)0 2 18 18 18 162 3 18 18 16 143
• 8 •FEATURES9. ASSEMBLY INSTRUCTIONS 10. IT IS IMPORTANT TO FULLY ASSEMBLE YOUR CHARGER BEFORE USE. FOLLOW THESE INSTRUCTIONS FOR ASSEMBLY: ITEM NO
• 9 •First, carefully lay the charger on its front to prepare for assembly.10.1 Assemble the foot (Item 6) using two ¼-20 screws (Item 5) and tighten
• 10 •OPERATING INSTRUCTIONS11. TIMER11.1 The main function of the timer is to prevent over charging while allowing a battery time to obtain a satisfa
• 11 •AMMETER11.4 The Ammeter indicates the amount of current measured in amperes that is being drawn by the battery. For example, in the 40 amp charg
• 12 •IMPORTANT: Using the ENGINE START feature WITHOUT a battery installed in the vehicle could cause damage to the vehicle’s electrical system.If th
• 13 •The Hydrometer or Electronic Method13.2 To nd the time needed to fully charge your battery, determine the bat-tery’s charge level with a hydrom
• 14 •MAINTENANCE INSTRUCTIONS14. Before performing maintenance, unplug and disconnect the battery char-14.1 ger (see sections 6.7 and 7.6).After use,
• 15 •TROUBLESHOOTING16. PROBLEM POSSIBLE CAUSE SOLUTION/REASONSNo reading on the ammeter. Clips are not making a good connection.4-amp charge rate is
• 16 •PROBLEM POSSIBLE CAUSE SOLUTION/REASONSShort or no start cycle when cranking engine.Drawing more than 300 amps.Failure to wait 3 minutes (180 se
• 17 •
TABLE OF CONTENTSSECTION PAGE1. IMPORTANT SAFETY INSTRUCTIONS 12. PERSONAL PRECAUTIONS 23. PREPARING TO CHARGE 34. CHARGER LOCATION 35
• 1 •IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL.IMPORTANT SAFETY INSTRUCTIONS1. SAVE THESE INSTRUCTIONS - The DieHard model 71991 Man
• 2 •WARNING – RISK OF EXPLOSIVE GASES.WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGER-OUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NOR-MAL
• 3 •PREPARING TO CHARGE3. If it is necessary to remove the battery from the vehicle to charge it, al-3.1 ways remove the grounded terminal from the b
• 4 •FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VE-6. HICLEA SPARK NEAR BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTE
• 5 •FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. 7. A SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTE
• 6 •BATTERY CHARGING - AC CONNECTIONS 8. GROUNDING AND AC POWER CORD CONNECTION 8.1 INSTRUCTIONS – Charger should be grounded to reduce risk of elect
Kommentare zu diesen Handbüchern